4-6
1) In the protection sleeve type
category screen (page 4-2),
move the cursor “ ” to the one
where you would like to modify
heater program settings and
press
key
.
<Modify heater program parameter>
2) Select the setup mode icon
. (Press
key.)
3) Move the cursor “ ” to the
heater program where you would
like to modify the settings and
select (press
key).
4) Move the cursor “ ” to the
item you would like to modify
and press
key.
5) Adjust the value using▼▲
keys. Move the cursor “
” to left
and right using
and
keys.
After adjustment, move the cur-
sor to
press
or SET
key.
The left-hand keys are some-
times used to move the cursor
“ ” up and down, and to left
and right.
key is pressed
to enter the selected item.
To Next Page
