6-12
Item Details
Conditioning Arc After electrodes are replaced, this function is used to condition
new electrodes. The number of times of conditioning arc is pre-
set. Arc Count is automatically reset after conditioning arc is
performed.
Self Inspection The circuit board, optical unit, motors and heat shrink oven are
automatically inspected.
Motor Calibration
The condition of all motors is inspected.
Caution for Arc Count Sets an arc count at which a caution for electrode replacement is
displayed. For further information, please refer to page3-4.
Warning for Arc Count Sets an arc count at which a warning for electrode replacement is
displayed. For further information, please refer to page x3-4.
Reset Arc Count Allows to reset the arc count.
*Total Arc Count (All Count) cannot be reset.
Restore Data All parameters except Arc Count and All Count are returned to
the factory setting.
<Maintenance settings> (Administrator mode)
To Next Page
