SummaSign Pro T-series Cutters User’ s Manual
General Information 1-2
• Interchangeable ballpoint pen for producing preview plots of sign designs
on paper.
• Interchangeable pouncing tool.
• Adjustable knife pressure (and offset settings) controlled by microprocessor.
• Communication with host computer via standard serial RS-232-C or
Centronics parallel interface.
• 12-key control panel.
• Metric or English units.
• User-addressable resolution : 0.1 mm, 0.025 mm, 0.001" or 0.005".
• Menu mode for selection of the cutter's power-up operating configuration.
• Convenient operator control via a 2-line 16-character liquid crystal display.
• Extensive internal test routines.
• Wide variety of cutting speeds (in metric or English units).
• Up to four separate user configurations stored in non-volatile memory.
• Media support system for automatic loading of media with optional
“shuffling” to guarantee tracking of longer signs.
• Automatic media pull from roll.
• Media sensing.
• Simple origin adjustment to any location.
• Concatenation and curve smoothing to obtain better cut quality.
• Multiple recut feature.
• Re-cut of last file.
• Knife depth and offset test.
• Overcut for easy weeding.
To Next Page
Loading...
