SummaSign Pro T1010 Pro - DM;PL Errors; HP;GL Origin

SummaSign Pro T-series Cutters User’ s Manual
Operation 2-16
2.4.10. DM/PL ERRORS
The DM/PL ERRORS submenu is used to determine whether or not different
DM/PL errors, such as illegal plot commands, invalid parameter ranges or
communication errors, will be displayed on the LCD. This menu will only be
displayed if PLOT LANGUAGE is set to DM/PL.
The DM/PL ERRORS submenu can be set to REPORTED or IGNORED.
On the LCD, the active setting is marked with an *.
The feature is activated by selecting REPORTED. It is normally used only when
attempting to debug a communication link between the cutter and the host
computer.
After the communication link has been debugged, select IGNORED to disable
the feature.
2.4.11. HP/GL ERRORS
The HP/GL ERRORS submenu is used to determine whether or not different
HP/GL errors, such as illegal plot commands, invalid parameter ranges or
communication errors, will be displayed on the LCD. This menu will only be
displayed if PLOT LANGUAGE is set to HP/GL.
The HP/GL ERRORS submenu can be set to REPORTED or IGNORED.
On the LCD, the active setting is marked with an *.
The feature is activated by selecting REPORTED. It is normally used only when
attempting to debug a communication link between the cutter and the host
computer.
After the communication link has been debugged, select IGNORED to disable
the feature.
2.4.12. HP/GL ORIGIN
The HP/GL ORIGIN submenu will only be displayed if the PLOT LANGUAGE is set
to HP/GL. (See Paragraph 2.4.4.) The HP/GL ORIGIN submenu is used to set the
origin in the centre (see HP/GL 758x) or the bottom-right corner (see HP/GL
7475) of the loaded media.
The HP/GL ORIGIN option can be set to RIGHT_FRONT or CENTRE.
On the LCD, the active setting is marked with an *.
If the cut is found to be incomplete, and is wholly located in the upper left
corner of the media then modify the HP/GL ORIGIN setting to RIGHT FRONT. If
the cut is found to be incomplete, and is wholly located in the lower right
corner of the media then change the HP/GL ORIGIN setting to CENTRE.