SummaSign Pro T1010 Pro - The Enter Key; The 1 and 2 Keys; The Jogging Keys; The Tool Up;Down Key

SummaSign Pro T-series Cutters User’ s Manual
Operation 2-5
MENU DESCRIPTION
USER CONFIG 1 (->4)
Selects a given active cutter configuration from one
of the four sets of configuration parameters stored in
the unit’ s memory
INTERNAL TEST
Activates one of the resident cutting plots provided
for informational purposes.
TABLE 2-1:
CONTENTS OF THE SUMMASIGN PRO T-SERIES MENUS
2.1.5. THE ENTER KEY
The key (ENTER) is used to select the item currently displayed on the LCD.
1 2 2.1.6. THE 1 AND 2 KEYS
The use of the 1 and 2 keys varies according to the operation in progress; their
use is displayed on the LCD as appropriate.
2.1.7. THE JOGGING KEYS
The use of the jogging keys varies according to the operation in progress.
For example, when working in the USER CONFIG menu, the or jogging
key is used to select the new user number and the or jogging key is
used to go to the previous or next menu item.
2.1.8. THE TOOL UP/DOWN KEY
The key (TOOL UP/DOWN) is used while the cutter is off line to raise or lower
the tool. Pressing the key once will lower the tool onto the media. Pressing
the key again will raise the tool.
If the tool is not moved for approximately eight seconds, it is raised auto-
matically.