SummaSign Pro T-series Cutters User’s Manual
Contour Cutting 5.11
5.8 CUTTING THE CONTOUR
• Follow the specific instructions for contour cutting in your software. If there
are no such instructions, follow the explanation below.
• Move the entire design (cross-marks and contours included) in your
software so that the origin mark is situated in the lower left corner of the
cutting area (In most sign-making software the orientation is landscape. If
not, you will have to rotate everything).
• Select the contours and cut them out:
♦ Make sure that only the contours are cut.
♦ Make sure that the origin of the cutting area is used.
⇒ Some software will shift the selected contours to the origin when
cutting. This can be avoided by adding a small rectangle that has its
lower left corner right in the origin. Select this rectangle together with
the contours.
To Next Page
Loading...
