SummaSign Pro T-series Cutters User’s Manual
Contour Cutting 5.8
5.6 LOADING THE CUTTER AND SETTING THE PARAMETERS
• Load the print out in the cutter as described in the User’s Manual. Make
sure that the cross-mark indicating the origin is situated at the front right.
• If you have selected the XY-adjustment method (see above), then open
Summa Cutter Control and select OPOS in the Configuration menu.
Origin point
X-Axis point
Origin point
X-Axis point
Y-Axis point
Y-Axis point
To Next Page
Loading...
