SummaSign Pro T-series Cutters User’ s Manual
Operation 2-6
2.1.9. THE TOOL SELECT KEY
The key (TOOL SELECT) is used to select one of the following tools :
a tangential knife
a drag knife
a ballpoint pen
a pouncing tool
To temporarily change the tool, press the key, then press the or
jogging key until the desired tool appears on the second line o the LCD. Press
the key to confirm the tool. An asterisk * appears next to the selected
tool. When the cutter is powered on the next time, the default tool will be
selected. For setting up the default tool see Section 2.4.5.
To Next Page
Loading...
