SummaSign Pro T-series Cutters User’ s Manual
General Information 1-5
T750 Pro T1010 Pro T1400 Pro
mm inch mm inch mm inch
Thickness
0.05 to
1.2
0.002 to
0.050
0.05 to 1.2 0.002 to
0.050
0.05 to 1.2 0.002 to
0.050
Max.cutting/
plotting area
720 27.7 995 39.2 1345 53
Min. Margin***
Unperforated
Perforated
25
55
1.0
2.2
25
55
1.0
2.2
25
55
1.0
2.2
Front Margin
25 1.0 25 1.0 25 1.0
Rear Margin
Sensor on
Sensor off
42
30
1.7
1.2
42
30
1.7
1.2
42
30
1.7
1.2
* Media lengths greater than 12 m (39 feet) can be handled, but compliance with
specifications is not guaranteed (will be dependent on media type, media size and other
parameters).
** Media lengths greater than 4 m (13 feet) can be handled, but compliance with
specifications is not guaranteed (will be dependent on media type, media size and other
parameters).
*** for positioning of the pinch rollers (see section 1.8.)
TABLE 1-2 :
SUMMASIGN PRO T-SERIES MEDIA SPECIFICATIONS (CONT’D)
Vinyl Types
A wide range of vinyl types has been evaluated and tested on the SummaSign
Pro T-series cutters. When using duly certified media, operation in accordance
with the functional specifications of the model is warranted. Other media
should be certified by CalComp before use to ensure performance in
compliance with specifications.
For a full list of all duly certified media suitable for friction drive operation, see
Appendix A.
Plotting Paper
Bond paper (120 g/m
2
recommended)
To Next Page
Loading...