SummaSign Pro T1010 Pro - Firmware; Performance; Certifications; Summasign Pro T-Series Firmware

SummaSign Pro T-series Cutters User’ s Manual
General Information 1-7
1.2.5. FIRMWARE
Language
DM/PL, HP/GL (758x emulation),
HP/GL/2
Supported character sets
Standard ASCII
Supported fonts
Sans serif (single stroke & medium)
ROM-based plots
Confidence plot, DIN plot
TABLE 1-5 :
SUMMASIGN PRO T-SERIES FIRMWARE
1.2.6. PERFORMANCE
Cutting specifications on 0.05 mm (0.002") wax-backed vinyl, total media
thickness not greater than 0.25 mm (0.010")
Axial speed
50 to 1000 mm/s 2 to 40 ips
Default speed
800 mm/s 32 ips
Acceleration
3 G 3 G
Addressable resolution
0.025 mm, 0.1 mm 0.001", 0.005"
Default resolution
0.025 mm 0.001"
Mechanical resolution
0.0127 mm 0.0005"
Accuracy
0.2% of move or 0.25
mm, whichever is
greater
*
0.2% of move or 0.010",
whichever is greater
*
Knife pressure
0 to 600 gr. 0 to 600 gr.
Pen pressure
0 to 600 gr. 0 to 600 gr.
Pouncing pressure
0 to 600 gr. 0 to 600 gr.
*
Excludes differences due to media expansion, stretching, etc.
TABLE 1-6 :
SUMMASIGN PRO T-SERIES PERFORMANCES
1.2.7. CERTIFICATIONS
CE Certificate
FCC Class A
Comply with UL 1950, CSA 950