SummaSign Pro T-series Cutters User’ s Manual
General Information 1-30
6. Lower the pinch roller lever to press the media firmly against the drive
sleeves. After one second the tool carriage automatically moves from the
right to the left to sense the usable media width.
NOTE
It is not necessary to unroll the media manually from the roll. The
cutter will unroll the media automatically during the load sequence.
7. The positioning and routing of sheet material is identical to that of roll
media.
8. The cutter is now ready for the actual load procedure, which may be
controlled from the control panel.
To Next Page
Loading...
