Installation, Operation, and Maintenance Manual
44 SUMMIT PUMP MODEL 2196 / 2196-LF / 2196-R / 2796
Figure H-8
5. Place the end plate (driver end) over the motor shaft as shown in Figure H-9.
Position the end plate in the annular groove at the rear of the coupling guard half
(driver end) and secure it with a bolt, nut, and two (2) washers through the round
hole at the rear of the guard half. Finger-tighten only.
Figure H-9 Figure H-9.5
6. Adjust the length of the coupling guard to completely cover the shafts and
coupling as shown in Figure H-10, by sliding the coupling guard half (driver end)
toward the motor. After adjusting the length, secure the guard with a bolt, nut and
To Next Page
Loading...
