Appendix B Using a Standalone JBOD Array (Sun StorEdge 3510 FC Array Only) B-7
B.6.1 Changing Your ID Switch Setting
Perform the following steps to change your ID switch setting:
1. Remove the bezel (the front faceplate).
See “Replacing the Front Bezel and Ear Caps” on page 8-26 for step-by-step
instructions for removing and replacing the front bezel and ear caps.
Caution – The plastic ear covers are snap-on parts that require care when you
remove them. If you remove the right plastic ear cap, take care to avoid breaking the
Reset push button directly below the ear cap.
2. Remove the left plastic ear cap from the front of the chassis.
3. Use the buttons to change the ID number.
4. Reattach the plastic ear cap and the bezel on the front of the chassis.
B.7 Connecting Sun StorEdge 3510 FC JBOD
Arrays
You can connect a Sun StorEdge 3510 FC JBOD array directly to a host server. Use
your standard host system disk management utilities for management of disks in a
Sun StorEdge 3510 FC JBOD array, such as partitioning and formatting. Refer to your
host system documentation for more information about disk management.
There are two ways to verify that you have a Sun StorEdge 3510 FC JBOD array (or
expansion unit) rather than a Sun StorEdge 3510 FC RAID array:
■ Check the back panel. The back panel of the Sun StorEdge 3510 FC JBOD
resembles the back panel shown in
FIGURE B-2.
■ Remove the front bezel and look at the labels on the bottom lip of the chassis. If
you have a Sun StorEdge 3510 FC JBOD array, one label contains this designation:
3510 AC JBOD (alternating current model) or 3510 DC JBOD (direct current
model).
To Next Page
Loading...
Need help?
General
