Appendix K Configuring a Windows NT Server K-5
K.2 Accessing the Firmware Application
From a Windows NT Server
To access the array from a Windows NT server through a serial port, use the
HyperTerminal connection you configured in “Setting Up the Serial Port
Connection” on page K-2 or install a VT100 terminal emulation program and use the
parameters described there.
To access the array through an Ethernet connection, perform the steps in “Setting an
IP Address” on page 4-19. To access the command prompt described there from a
Windows NT server, perform this step:
● Choose Programs → Command Prompt
K.3 Enabling a Windows NT Server to
Recognize New Devices and LUNs
Before beginning this procedure, make sure that your system has been upgraded
with Service Pack 2 or higher.
Before beginning this procedure, make sure that you are using a supported FC HBA
such as a QLogic QLA2310 or QLogic QLA2342. Refer to the release notes for your
array for current information about which HBAs are supported.
Also make sure that you are using a supported driver for your HBA. For the
QLA2310 or QLA2342, use driver version 8.1.5.12 or later.
Note – When the Microsoft Windows operating system recognizes the Sun StorEdge
3510 or 3511 FC array’s SCSI Enclosure Services (SES) processor and identifies it as a
SE3510 or SE3511 Enclosure, it might prompt you to supply a driver. This is standard
plug-and-play behavior when unknown devices are encountered, but no device
driver is necessary. If you see this prompt, simply click Cancel. If you have multiple
arrays, you might see this prompt more than once. Each time you see this prompt,
click Cancel.
1. Boot your system and verify that the HBA basic input/output system (BIOS)
recognizes your new FC device.
To Next Page
Loading...
Need help?
General
