K-1
APPENDIX
K
Configuring a Windows NT Server
This appendix provides platform-specific host installation and configuration
information to use when you connect a Sun StorEdge 3510 or 3511 FC array to a host
running the Windows NT Server operating system.
The Sun StorEdge 3510 and 3511 FC Arrays support Microsoft Windows NT 4.0,
Service Pack 6A or greater, in either single-path or dual-path configurations. Dual-
path configurations use the Sun StorEdge Traffic Manager 3.0 for Microsoft Windows
NT.
If you are going to use dual-path instead of single-path configurations, see the Sun
StorEdge Traffic Manager 3.0 Installation and User’s Guide for Microsoft Windows 2000
and Windows NT for detailed instructions about setting up the device driver on the
server and for additional information about configuring your Windows NT server.
Customers interested in Sun StorEdge Traffic Manager 3.0 for multiplatform support
should contact Sun Sales or visit:
http://www.sun.com/sales
For more information about multiplatform support, see:
http://www.sun.com/storage/san/multiplatform_support.html
The information in this appendix supplements the configuration steps presented in
Chapter 6, and covers the following steps:
■ “Setting Up the Serial Port Connection” on page K-2
■ “Accessing the Firmware Application From a Windows NT Server” on page K-5
■ “Enabling a Windows NT Server to Recognize New Devices and LUNs” on
page K-5
■ “Determining the World Wide Name for Windows NT Servers” on page K-9
To Next Page
Loading...
Need help?
General
