Sunless VersaSpa Pro - 4-Position Stance

Included on the base of the Versa6SDPro
TM
are two foot locators, each having the
numbers 1,2,3 and 4. To simplify the process during the spray session, the automated
voice instructions will tell you what number your toes should be on and what number
your heels should be on.
4-Position Stance
Step 1. Once in the Versa6SDPro
TM
application area, make sure the unit is properly
reset by visually checking that the green start button (located on the spray nozzle
column inside the Versa6SDPro
TM
spray booth) is blinking slowly. If the green start
button is not blinking slowly, notify salon operator.
Step 2. If the Versa6SDPro
TM
booth is properly reset (see Step 1), remove jewelry and
makeup, then disrobe. Apply nose filter and lip balm.
Step 3. Put on your hair cap (position cap slightly behind hairline and ears) and foot
coverings (if foot coverings are available and desired).
Step 4. Apply blending lotion to palms (if desired), cuticles of fingers, fingernails,
between fingers, bottom of feet, and between toes (if not using foot protection). Avoid
touching any part of the body after applying blending lotion.
Step 5. Enter the Versa6SDPro
TM
application area.
Step 6. Start in the position 1 stance (see Position #1 figure below), standing with your
toes on #1 and your heels on #.
Step 7. Once in the proper position, press the green start button (located on the spray
column) to initiate the 4 misting cycles and dry cycles
Note: The Versa6SDPro
TM
performs 4 misting cycles, which correspond to 4
recommended positions (see figures below). The misting cycle lasts approximately 7
seconds and starts from the top and moves down on the first cycle. Next it will begin a
12 second dry pass on the way up while you remain in this position.
Section 4!
Using Your Versa6SDPro
TM
28