Sunless VersaSpa Pro - Page 37

Step 8. After the first misting and drying cycle is complete, follow the voice guided
instructions and move to the position 2 stance (see Position #2 figure below) and stand
with your toes on #2 and your heels on #4. It will now spray you on the way down,
pause, and then dry you while the nozzles are moving back up.
Step 9. After the second misting and drying cycle is complete, follow the voice guided
instructions and move to the position 3 stance (see Position #3 figure below) and stand
with your toes on #3 and your heels on #4. It will now spray you on the way down,
pause, and then dry you while the nozzles are moving back up.
Step 10. After the third misting and drying cycle is complete, follow the voice guided
instructions and move to the position 4 stance (see Position #4 figure below) and stand
with your toes on #4 and your heels on #1. It will now spray you on the way down,
pause, and then dry you while the nozzles are moving back up.
Step 11. After the fourth misting and drying cycle is complete, follow the voice guided
instructions for any additional dry passes. If there are additional dry passes, you will be
guided to remain in this position for the first additional dry pass and then it will guide you
to turn around into position 1 with your toes on #1 and your heels on #4 for your final dry
pass.
Step 12. Exit the Versa6SDPro
TM
and remove hair cap, foot protection, nose filters, and
any other protective items, then discard them.
Step 13. Wipe blending lotion off hands (if used) using a towel or tissue. (To avoid
potential streaking, make sure the towel is not the same one used to remove excess
blending lotion prior to tanning.)
Step 14: Get dressed, put all jewelry back on if necessary, and start enjoying your
beautiful Versa6SDPro
TM
application.
Note: The Versa6SDPro
TM
you are using may have a different sequence for the dry
passes where it will perform all misting passes first, then perform all drying passes at the
end. Simply follow the voice guided instructions to complete the session.
Note: Remember, do not shower for 4-6 hours after tanning to allow the Versa6SDPro
TM
solution to absorb into your skin.
Section 4!
Using Your Versa6SDPro
TM
29