fire. Periodically examine the cord of the Versa6SD Pro
TM
unit, and if the
appearance indicates damage or deterioration, unplug it, and immediately
discontinue use of the Versa6SDPro
TM
booth. Please contact Sunless, Inc.
Technical Support at (855)450-3500 for instructions on how to obtain
replacement parts when necessary.
Protect the power cord from physical or mechanical abuse, such as being
twisted, kinked, pinched, closed in a door, or walked upon. Pay special attention
to plugs, wall outlets, and the point where the power cord exits the Versa6SD
Pro
70
booth.
Keep cords away from heated surfaces.
Do not allow water to accumulate on the floor around or near the Versa6SDPro
TM
booth.
Never handle the plug, electrical cord, or touch the wall outlet with wet hands.
To reduce the risk of fire or electric shock, do not expose this unit to rain or
moisture.
Your Versa6SDPro
TM
booth is equipped with a Residual Current Breaker
withOverload, RCBO. RCBO’s are designed to disconnect the electrical
circuitquickly in case of a ground fault or electrical overload.
Make sure machine is not operating before unplugging.
Close adult supervision is necessary when this product is used near children. Do
not allow children to play in or around the booth, or to play with the touchscreen
controller. Severe Injury or harm could occur due to moving parts and electrical
features of the Versa6SDPro
TM
booth.
Use this product only as intended per the instructions in this manual. Do NOT
use solutions that are not recommended by Sunless, Inc..
iv
To Next Page
Loading...