Chapter 7: Troubleshooting and Support
System Boot Failure
If the system does not display Power-On-Self-Test (POST) or does not respond after the
power is turned on, try the following:
•
Memory Errors
•
•
details.
•
results.
Losing the System Setup Conguration
• Always replace power supplies with the exact same model that came with the system. A
•
replace it.
When the System Becomes Unstable
If the system becomes unstable during or after OS installation, check the following:
•
• Memory: Make sure that the memory modules are supported. Refer to the product page on
our website at www.supermicro.com. Test the modules using memtest86 or a similar utility.
• Storage drives: Make sure that all drives work properly. Replace if necessary.
• System cooling: Check that all heatsink fans and system fans work properly. Check
To Next Page