To Next Page

To Previous Page

C-4

X10SLV/-Q Motherboard User’s Manual

8. When a DOS prompt appears, enter AMI.BAT BIOSname.### at the prompt.

Note: Do not interrupt this process until BIOS ashing is completed.

9. After seeing the message that BIOS update is completed, unplug the AC pow-

er cable from the power supply to clear CMOS, and then plug the AC power

cable in the power supply again to power on the system.

10. Press <Del> continuously to enter the BIOS Setup utility.

11. Press <F3> to load default settings.

12. After loading default settings, press <F4> to save the settings and exit the

BIOS Setup utility.

Supero X10SLV User Manual

Questions and Answers: