4-14
X10SLV/-Q Motherboard User’s Manual
Gfx (Graphics) Low Power Mode
Select Enabled to use the low power mode for internal graphics devices installed
in a small form factor (SFF) computer. The options are Enabled and Disabled.
PCI-E Conguration
This item displays the information of the (graphics) device installed on a PCI-E
slot.
SLOT1 PCI-E 2.0 X16 (X10SLV only)
SLOT1 PCI-E 3.0 X16 (X10SLV-Q only)
SLOT1 PCI-E 2.0 X16- Gen X, option support up to Gen2 (X10SLV only)
SLOT1 PCI-E 3.0 X16- Gen X, option support up to Gen3 (X10SLV-Q only)
This feature allows the user to select PCI-E support for the device installed on
Slot1. The options are Auto, Gen1 (Generation 1), and Gen 2 (Gen3 is an added
option for X10SLV-Q).
Detect Non-Compliant Device
Select Enabled for the AMI BIOS to automatically detect a PCI-E device that is
not compliant with the PCI-E standards. The options are Enabled and Disabled.
Program PCI-E ASPM After OpROM
PCI-E ASPM, the Active State Power Management for PCI-Express slots, is a
power management protocol used to manage power consumption of serial-link
devices installed on PCI-Exp slots during a prolonged off-peak time. If this item
is set to Enabled, PCI-E ASMP will be programmed after OpROM. If this item
is set to Disabled, the PCI-E ASPM will be programmed before OpROM. The
options are Enabled and Disabled.
SLOT1 PCI-E 2.0 X16 ASPM (X10SLV only)
SLOT1 PCI-E 3.0 X16 ASPM (X10SLV-Q only)
Use this feature to set the ASPM (Active State Power Management) level for
the graphics device installed on a PCI-E or PCI slot specied by the user. The
options are Disabled, ASPM L0s, ASPM L1, ASPM L0sL1, and Auto.
DMI Link ASPM Control
Use this feature to set the ASPM (Active State Power Management) state on
the SA (System Agent) side of the DMI Link. The options are Disabled, L0s,
L1 and L0sL1.
To Next Page
Loading...
Need help?
General
