Supero X10SLV - SATA DOM Power (JSD1); System Management Bus (JSMB1); GPIO Header (JGPIO 1)

2-26
X10SLV/-Q Motherboard User's Manual
SATA DOM Power
SMB Connector
JGPIO Header
A
B
C
C
B
A
SATA DOM Power (JSD1)
The SATA DOM Power on JSD1 is used
to supply power to SATA Disk-on-Module
(DOM) solid-state storage devices.
SATA DOM Power
Pin Denitions
Pin# Denition
1 +5V
2 Ground
3 Ground
System Management Bus (JSMB1)
A System Management Bus header is lo-
cated at JSMB1. Connect the appropriate
cable here to use the SMB features of the
motherboard.
System Management
Bus
Pin# Denition
1 Data
2 Ground
3 CLK
4 No Connection
GPIO Expander
Pin Denitions
Pin# Denition Pin Denition
1 VCC5 2 GND
3 GP0 4 GP1
5 GP2 6 GP3
7 GP5 8 GP5
9 GP6 10 GP7
GPIO Header (JGPIO 1)
The JGPIO1 header is located near the
SATA connectors on the motherboard.
The JGPIO header is a general-purpose
I/O expander on a pin header via the
SMBus. See the table on the right for
pin denitions. Refer to the board layout
below for the locations of the headers.