Supvan TP76E - Replacement of Half-cutter and Cutting Board Assembly

SUPVAN Chapter 3 Consumable Installation
18
figure (2.5cm). Adjust the tube into appropriate direction.
3.4 Replacement of Half-cutter and Cutting Board Assembly
3.4.1 Replacement of cutter
Pull the old cutter out, and insert a new one.
3.4.2 Replacement of cutting board assembly
(1) Take the label or tube out of tube printer.
(2) Pull out the old cutting board assembly.
(3) Insert a new one.
Note:

Please be careful not to hurt your fingers when replace any cutter and
cutting board assembly.
 When the cutter has been used for long time and the half-cutting
effect is not good, please replace the complete set of cutter and
cutting board assembly at the same time.