Supvan TP76E - Simple Troubleshooting

SUPVAN Chapter 8 Others
53
8.3 Simple Troubleshooting
TP76E Tube Printer
Fault Phenomenon
Fault Cause
Troubleshooting Method
The content is not
centered after half-cut
Different media with
different segment
lengths
Please adjust the position
of contents in segment
length by Margin.
Actual segment length is
different from the setting
Different media
Please adjust by the Test
function.
Half-cut effect is not good
The half cutter is blunt
Please replace it with a new
one.
No printing action on
segment printing
Not install any driving
software
Please install the driving
software.
Printing is not clear
Tube media is too hard
There are stains on tube
surface
Please clean the tube or
replace it with a qualified
one.
Ribbon is curled
Please take it out. Use it
after coiling and leveling, or
replace it.
Print head is worn or
scratched
Please replace it.
Media specification does
not set correctly.
Please change the media
type setting of machine
which should be same as
the one in actual operation.
Ambient temperature is
too low or high
Please adjust the printing
density or change the
ambient temperature of
machine operation.
Print content is
incomplete
Character size is set too
large
Please reset a smaller
character size.
Ribbon is out of way
Please take it out and
adjust it
Media specification does
not set correctly
Please change the media
type setting of machine
which should be same as
the one in actual operation
Print head is worn or
scratched
Please replace it.