Supvan TP76E - Print of Label; Print of Heat Shrink Tube

SUPVAN Chapter 4 Basic Operation
20
4.2 Print of Label
Install the label, then press 【Media 】 to the media option. It will display as
below:
Make a correct selection with 【↓】and 【↑】to select correctly according to the
specification of installed label. Press【Enter】to go into the file input interface to
edit contents.
Input letters or symbols in turn such as S, U, P, V, A, and N, and there will be 1:
SUPVAN displaying on screen.
Press 【Enter】, and the next segment will be generated automatically. Input
“SUPVAN” again, and it will display as below:
20
4
Y
N
1
4
1: SUPVAN
2: SUPVAN
En
Press 【Print】 , the machine will print the input contents automatically with
half-cut and full cut. During the printing process, LCD will display Printing…….
After printing, return to the file input interface automatically.
Note:

For 6mm label, please select single row and character size 1, 2 and 3.
 For 9mm label, please select single row and character size 1, 2, 3, 4 and
5.

For 12mm label, please select single row and character size 1, 2, 3, 4, 5, 6
and 7.
4.3 Print of Heat Shrink Tube
Install the heat shrink tube, then, press【Media】 to enter the media option.
After select Shrink Tube, press 【Enter】 to get into the file input interface to
input the contents.
Input letters or symbols in turn such as S, U, P, V, A, and N, and there will be 1:
SUPVAN displaying on screen.
20
4
Y
N
1
4
Tube
Label
Shrink tube