Supvan TP76E - Delete Seg; Double Rows

SUPVAN Chapter 5 Operation of Function Key
44
3, this indicates to replace the cutter unit necessarily.
5.22
【
Delete Seg
】
This function is to delete the segment content that the cursor is located.
Move the cursor to any segment to be deleted. Press【Delete Seg 】 , it will
display as below:
20
4
Y
N
1
4
Delete the current segment?
Yes No
Select Yes to delete the segment.
The segment cannot be restored after being deleted. The rest segments will be
reordered.
5.23 【Double Rows】
This function is to input double rows in a segment. Input the first line of content
into the segment, then, move the cursor to the end of the segment. Press
【Double Rows】, the double rows notification: = will appear, then, re-input the
second row content.
Note:
 When printing double rows on 9mm label, character size can only be
selected as 1 and 2.
 When printing double rows on 12mm label, character size can only be
selected as 1, 2 and 3.
 Do not set any double rows if print 0.5
2
, 0.75
2
, 1.0
2
, 1.5
2
, 2.5
2
, and 4.0
2
tubes.
 When printing double rows on 6.0
2
tube, character size can only be
selected as 1 and 2.
 After setting a double rows print, press the double rows key, and there will
be a display shown on screen: Already double rows.
5.24 【X
2
】【X
2
】
This function is to generate a superscript or subscript.
5.24.1 X
2
After moving the cursor to a character to generate the superscript, press