Suzuki Burgman AN400 Service Manual

1I-11 Starting System:
• Apply thread lock on the starter clutch bolts and
tighten them to the specified torque.
Tightening torque
Starter clutch bolt: 26 N·m (2.6 kgf-m, 19.0 lb-ft)
: Thread lock cement 99000–32050
(THREAD LOCK CEMENT 1342 or equivalent)
CAUTION
!
After installing the starter driven gear, check
that the clutch functions properly.
Starter Button Inspection
B705H11906012
Refer to “Starter Button Inspection in Section 9B
(Page9B-10)”.
Specifications
Service Data
B705H11907002
Electrical
Unit: mm (in)
Tightening Torque Specifications
B705H11907003
NOTE
The specified tightening torque is also described in the following.
“Starter Motor Components (Page1I-3)”
“Starter Clutch Component (Page1I-9)”
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque Specifications in Section
0C (Page0C-7)”.
I705H1190027-01
Item Standard / Specification Note
Starter relay resistance 3 – 6 Ω
Starter motor brush length
Standard 7 (0.28)
Limit 3.5 (0.14)
Fastening part
Tightening torque
Note
N⋅mkgf-mlb-ft
Starter motor mounting bolt 7 0.7 5.0 )(Page1I-4)
Starter motor lead wire bolt 3 0.3 2.0 )(Page1I-4)
Starter motor housing bolt 4 0.4 3.0 )(Page1I-5)
Starter clutch bolt 26 2.6 19.0 )(Page1I-11)

Suzuki Burgman AN400 Specifications

General

Engine Type	4-stroke, 1-cylinder, liquid-cooled, DOHC
Displacement	400cc
Bore x Stroke	81.0 mm x 77.6 mm
Fuel System	Fuel injection
Starter	Electric
Front Suspension	Telescopic, coil spring, oil damped
Front Brake	Disc, twin
Rear Brake	Disc
Front Tire	120/70-15M/C 56S, tubeless
Rear Tire	150/70-13M/C 64S, tubeless
Curb Weight	215 kg
Fuel Capacity	13.5 liters
Transmission	CVT
Width	765 mm
Seat Height	735 mm
Rear Suspension	Swingarm type, coil spring, oil damped
Length	2235 mm
Height	1350 mm
Wheelbase	1580 mm