10
LIFTING THE MOTOR
Attach the sling straps to two rear lifting eyes on the engine.
Then install lift to sling straps.
Sling the motor and align with the holes drilled in transom.
DO NOT USE FRONT LIFT EYE
WHEN UNCRATING THE MOTOR
The front lift eye is not designed nor intended to be
used for removing the motor from its horizontal posi-
tion in the shipping crate. Attempting to lift the motor
from its horizontal crated position using the front lift
eye creates a chain or sling angle which can cause the
motor to swing when it is lifted. This may result in per-
sonal injury or cause damage to the engine block.
Lifting the outboard motor using a hoist with insuffi-
cient capacity can result in serious injury and/or dam-
age to the outboard motor.
Use a hoist which has a minimum lift capacity of at
least 450 kg (1000 lbs.) when lifting the motor.
Failure to use the proper attachment point for lifting
the outboard motor can result in severe injury and/or
damage to the outboard motor.
Use the lifting eye only. Do not lift the motor using a
flywheel lifting attachment.
To Next Page
Loading...
