105
REGISTERING THE FIRST AND SECOND KEY-FOB ID CODES
ID codes of individual key-fobs must be registered to enable the keyless start system.
To register the ID code of the first and second key-fob, do the following:
(1) Complete the system wiring.
(2) Connect the battery cable and sub battery cable to the battery.
How to register the first key-fob ID code
(3) Make sure the first key-fob is placed less than 0.3 m (12 in)
from the keyless control unit.
The second key-fob must be separated more than 1 m
(3.2 feet) from the keyless control unit, or lock the second
key-fob function by operating its lock button.
(4) Turn the main switch knob from “Neutral” to “ON & OFF”,
then release the knob.
The red LED on the key fob lights up; within 10 seconds,
briefly press
the key fob button.
NOTE:
If the buzzer emits five (5) short sounds when the main switch
knob is turned from “Neutral” to “ON & OFF” position, the key
fob function may be locked.
Press the lock button on the key-fob for more than one second
to unlock the key fob function. Then perform step 4 again.
(5) When the initial registration is successful, the buzzer emits
one (1) short sound, followed by one (1) long sound, and
the key fob’s red LED turns off.
NOTE:
• If the ID code registration is not successfully completed, the
buzzer emits five (5) short sounds.
• If the registration is not successful, wait for about one minute,
then perform step 4 again.
NOTE:
Two key-fob ID codes must be registered.
The system cannot be operated until two ID codes are
registered.
First key fob Second key fob
“ON & OFF”
Main switch knob
“N”
Lock button
Red LED
To Next Page
Loading...
