104
(10) Click the “OK” button to complete the registration of the engine location.
The system then returns to the main menu.
(11) Turn the emergency key to the “Neutral” position.
Before going to the next step, wait for about one minute until the ECM internal circuit is turned
OFF.
(12) Change the connection of the diagnostic harness to the next engine (ECM).
The position of each engine must be registered to the ECM using the same procedure.
NOTE:
Once an ECM has been connected and paired to a key-
less start control unit, the ECM/outboard cannot be
started with a normal key switch.
To unpair an ECM from an keyless control unit, see
page “UNPAIRING AN ECM FROM THE KEYLESS
START SYSTEM”.
To Next Page
Loading...
