Suzuki DF350A - Unpairing an Ecm from the Keyless Start System

111
UNPAIRING AN ECM FROM THE KEYLESS START SYSTEM
When the outboard motor is resold, removed and started in a
test tank, or if it is necessary to use the ECM on another engine,
the ECM must be unpaired with the keyless control unit by eras-
ing the ID code in the ECM.
Do the following to erase the ID code:
NOTE:
The key-fob ID code registered in the keyless control unit cannot
be erased from the keyless control unit.
(1) Make sure the key-fob and the keyless control unit are
within communication range.
(2) Turn the main switch knob from “Neutral” to “ON & OFF”
position, then release the knob.
Confirm that the keyless start system has been turned ON.
(3) Connect the black lead wire and the yellow lead wire in the
keyless control harness.
“ON & OFF”
Main switch knob
“N”
“N”: Neutral
Yellow
Black
B
B
Y
B
B
Y
Y: Yellow, B: Black