115
RIGGING HOSE ADAPTER KIT
Contained parts
INSTALLATION
1. Insert the remote control wire, battery cable into the rigging
hose adapter.
2. Connect the fuel hose to fuel hose joint.
For the procedure to connect the fuel hose to fuel hose joint,
refer to “FUEL HOSE” section.
3. Put on the rigging hose adapter to rigging port grommet,
then secure the adapter with pins and E-rings as shown in
the illustration.
The pin must be installed to tab of both side.
NOTE:
Before connecting the rigging hose (5) to the rigging hose
adapter (2), apply silicone seal to clearance of a rigging hose (5)
and the rigging port grommet (1), to prevent water entry.
: 93691-80030: SUZUKI Silicone Seal (100 g)
Item Part name Part number Q’ty
— Rigging hose adapter kit 67300-98J10 1
1 • Rigging hose adapter • 67361-90J10 1
2 • Pin • 09208-06009 2
3 • E-ring • 09383-04002 2
1. Rigging port grommet
2. Rigging hose adapter
3. Pin
4. E-ring
5. Rigging hose
3
4
2
5
1
1
2
3
3
4 4
To Next Page
Loading...
