41
INSTALLATION OF BCM (Boat control module)
NOTICE
The following conditions must be observed when installing BCM.
• Install in a dry protected area.
• Area selected for installation must not exceed 75 °C (167 °F)
• Anchor BCM to a flat solid surface.
NOTE:
Engine will not start with improper combination of BCM and ECM.
In this case:
• Caution buzzer sounds
• Gauge screen indicates “Check Control Unit C”
• Engine cranking does not take place
For this model, BCM must be used with the following part number.
For single, twin and triple engine installation: P/N: 36770-98J13 and later
For quadruple engine installation: P/N: 36770-98J21 and later
(1) Install the cushion 1 to the BCM (boat control module).
(2) Install the holder R 2 and holder L 3 to the BCM and
install the BCM with four (4) screws.
Installing and routing the harness of SPC system components in an inappropriate location can
result in system failure.
Be sure to take the following precautions:
• Avoid installing the BCM where it will be exposed to direct sun.
• Install the BCM in a dry location, as far as possible from where it might get splashed with
water.
• Install the BCM so that the connector faces downward.
• Install the BCM on a flat surface so it will not fall off during boating.
To Next Page
Loading...
