40
WIRE CONNECTION
Gr
B/G
B
TO HARNESS
BATT+
TROLL MODE
SWITCH
CAP
TO
BUZZER
TO
PANEL SWITCH
TO BCM
TO
MAIN SWITCH
TO PTT SW, LPS
GND
36623-98J20
36623-98J30
Gr
Gr
B
B
Y/B
SPC model;
A
“Cap” is connected to the ( ) marked connector in the “BCM Harness”.
When the “Troll Mode Switch” is installed, it is necessary to remove the “Cap”
from the ( ) marked connector.
The removed “Cap” should be used as the plug for the unused connector.
NOTE:
The unused connector is for the “Analog Trim Meter”.
Therefore, it is not used for the SPC model.
BCM
Harness
SPC model, 1st Station
SPC; Suzuki Precision Control
TO HARNESS
GND
BATT+
TROLL MODE
SWITCH
CAP
TO BCM
TO
EMERGENCY
STOP SWITCH
TO PTT SW, LPS
36624-98J02
36624-98J11
B/G
Gr
TO
BUZZER
TO
PANEL SWITCH
Gr
B
B
Gr
BCM
Harness
SPC model, 2nd Station
To Next Page
Loading...
