66
CONNECTING PC AND BCM
(1) Connect your PC to the BCM of the outboard motor by
using the special tools.
NOTE:
• Check that your PC and the main switch of the outboard motor
are off before connecting the diagnostic harness.
• If two stations are available, a master BCM and sub BCM are
installed. To calibrate the system, connect the diagnostic har-
ness to the master BCM (main switch side BCM).
(If only one station is available, only the master BCM is
installed.)
Connect the SDS diagnostic harness to the SDS
4-pin communication connector of or .
To Next Page
Loading...
