82
MULTI FUNCTION GAUGE DIMENSIONS & MOUNTINGS
NOTICE
HOLE SIZES
NOTE:
Check area behind panel to be sure there is ade-
quate clearance for installing instruments and wires
and to make sure that other components will not be
contacted when cutting holes.
Installation, Multi Function Gauge:
• Panel cut-out, 85 mm (3.35 in.) hole saw
FASTENING TO PANEL
(1) Install the gasket (1) to gauge.
(2) Insert the gauge (2) into panel hole.
(3) Thread the nut (3) onto threaded housing of gauge and
tighten to back of panel.
Installing the gauges in an inappropriate location can result in gauge failure or operating diffi-
culties.
• Do not install the gauge in a location where it is likely to be sprayed with water.
Exposure to water can cause failure of the gauge.
• Install the gauges on the dashboard so that they can be easily operated and viewed by the
operator.
MENU SET
105 (4.13)
105 (4.13)
Unit: mm (in.)
84.5 (3.32)
96 (3.78)
54.9
(2.16)
16.5
(0.65)
105 (4.13)
Unit: mm (in.)
φ
φ
2
3
1
To Next Page
Loading...
