16
2. Turn the adjust screw 2 with a hexagon wrench.
Turning the adjust screw clockwise:
friction will increase
Turning the adjust screw counterclockwise:
friction will decrease
NOTICE
NOTE:
Be careful when tightening the adjust screw so that the tighten-
ing torque does not exceed 2.5 N·m.
3. Reinstall the rubber grommet(s) 1.
DETENT FEELING ADJUSTMENT
Adjust the detent feeling using the following procedure.
The adjusting procedure explained here and the figures shown
in right side are for dual top mount remote control box as an
example.
The adjusting procedure for the single top mount remote control
box is basically the same as those of dual top mount remote
control.
1. [Single remote control box]
Remove the rubber grommet 1.
[Dual remote control box ]
Remove two rubber grommets 1 located on both sides of
the remote control box.
Over tightening the friction adjust screw can cause
damage to the mechanism.
Do not over tighten the friction adjust screw.
To Next Page
Loading...
