21
INSTALLATION
(1) Select the proper position of the remote control box, and
stick the template on the selected position.
(2) Cut and drill as instructed on the attached template.
NOTE:
After drilling the holes, make sure opening is free of sharp
edges.
(3) Fit the bolts 3 and the washers 4 into the slots located on
the corner of main frame under as shown.
(4)
Peel the release paper of the seal 2. Stick the seal 2 on the
back side of the Remote Control Box main frame as shown.
(5) Route the BCM harnesses through the opening and connect
with the wire harnesses of the Remote Control Box.
TOP MOUNT CONTROL MOUNTING TEMPLATE
67200-98J02
67200-98J12
ALL CONTROLS
Frame
To Next Page
Loading...
