20
CONTAINED PARTS
Item Part name Q’ty
A Bolt (M5-50 mm) 4
B Washer (10 mm OD) 4
C Washer (16 mm OD) 4
D Nut (M5) 4
E
Seal (Single type) 1
Seal (Dual type) 1
F Spanner 1
G Allen wrench 1
ELECTRONIC REMOTE CONTROL BOX
INSTALLATION INSTRUCTIONS
PART NUMBER AND APPLICABLE MODEL
PART NUMBER PART NAME APPLICABLE MODEL
INSTALLATION TIME
67200-98J02 R/CON ASSY, SINGLE TOP MOUNT
DF300T/Z
1.0hr
67200-98J12 R/CON ASSY, MULTIPLE TOP MOUNT
IMPORTANT
WARNING/CAUTION/
NOTE
Please read this manual and follow its instructions carefully. To emphasize special information, the symbol
and the words WARNING, CAUTION and
NOTE
have special meanings. Pay special attention to the mes-
sages highlighted by these signal words.
PRECAUTION BEFORE INSTALLATION
These instructions are intended for use by technicians who already possess the basic knowledge and
skills to service SUZUKI outboard motors.
Electronic calibration required before use – After installation of this product, the Suzuki Precision
Control systems require electronic calibration. The calibration must not be attempted by anyone other
than a person who has been specifically trained in the Suzuki Precision Control system. Improper
electronic calibration of the system will make this product and/or the system inoperable or unsafe for
use.
NOTE AFTER INSTALLATION
Please instruct the customer in the use of the detent and friction adjustment of a remote control, and
hand over these installation instructions to the customer. Section 4 of these instructions is necessary
for a customer to conduct the detent and friction adjustment of a remote control.
WARNING
Indicates a potential hazard that could result in death or injury.
CAUTION
Indicates a potential hazard that could result in engine damage.
NOTE:
Indicates special information to make maintenance easier or instruction clearer.
M000 154 50
Aug., 2007 Printed in Japan
To Next Page
Loading...
