27
REMOTE CONTROL POSITION
Set the Remote Control Box in a position in which it does not
obstruct the operations of the control lever and switches. Make
sure there is no obstruction on the path of the remote control
wire harness.
Allow a space so that the back of the Remote Control Box does
not contact any other parts.
Provide a space so that the remote control wire harness can be
routed without bending sharply.
INSTALLATION
(1) Select the proper position for the remote control, and attach
the template on the selected position. Cut out the shaded
portion and drill 4 installation holes of 6.5 mm (17/64 in.)
diameter.
NOTE:
After drilling the holes, make sure the opening is free of sharp
edges.
(2) Remove the top cover of the remote control by using a flat
head screwdriver as leverage.
(3) Route the BCM harnesses through the installation hole and
connect with the wire harness of the remote control box.
50 mm
(1-63/64 in.)
To Next Page
Loading...
