28
(4) Rotate the remote control box 1 turning in 90 degrees as
shown in the figure and place it into the installation hole.
(5) After the base of the remote control 1 touches the mount-
ing panel, turn the remote control clockwise to its normal
position.
(6) Fasten the sets of Bolt 2, Washer 3, 4, Nut 5 as shown
in the figure.
Tightening Torque: 4.5 – 5.5 N·m (3.3 – 4.1 lb-ft)
(7) Reinstall the top cover to the Remote Control box.
To Next Page
Loading...
