26
REMOTE CONTROL LEVER
FRICTION ADJUSTMENT
Adjust the lever friction using the following procedure.
1. Remove the rubber grommet 1.
2. Turn the adjust screw 2 with a hexagon wrench.
Turning the adjust screw clockwise:
friction will increase
Turning the adjust screw counterclockwise:
friction will decrease
NOTE:
Be careful when tightening the adjust screw so that the tighten-
ing torque does not exceed 2.5 N·m.
NOTICE
3. Reinstall the rubber grommet 1.
Over tightening the friction adjust screw can cause
damage to the mechanism.
Do not over tighten the friction adjust screw.
To Next Page
Loading...
