Suzuki DF350A - Connection of Control Harness; Connecting Components

30
CONNECTION OF CONTROL HARNESS
CONNECTING COMPONENTS

1. Connect the Remote control harness
2. Connect the key less control harness
3. Connect the terminal resistor
4. Connect the sub-battery cable
5. Connect the isolator line
6. Remote control harness (engine side)
(1) Connect the 16-pin connector of the remote control har-
ness to the connector on the engine side.
Open, short circuit or poor electrical connections can result in loss of electronic throttle and
gear shift control.
Be sure to take the following precautions:
• Do not cut or extend the wiring harness and lead wires.
Water may enter from the joint of the wiring harness or lead wire, causing a continuity error at
the connections, resulting in shifting and throttle control errors.
Sub-battery cable
Remote control harness
1
2
3
4
5
6