107
ADDING KEY FOBS
Every key fob has a unique identification code.
The keyless start system can only be controlled by a key fob that
has been registered in the keyless control unit.
NOTE:
The first and second key fob ID codes are registered in the key-
less control unit at the time of the initial registration for the unit
ID code.
Refer to “REGISTERING THE FIRST AND SECOND KEY-FOB
ID CODES” in this manual.
NOTE:
A maximum of six (6) key-fobs can be registered in a keyless
start control unit.
Each additional key-fob must be registered.
Register one key-fob at a time.
To register additional key fob ID codes, do the following:
(1) Make sure the engine is stopped, the control lever is in neu-
tral, and the key fob and the keyless start control unit are
within proper range.
(2) Turn the main switch knob from “Neutral” to “ON & OFF”
position and release it.
Confirm that the “SELECT” switch green LED turns on.
“ON & OFF”
Main switch knob
“N”
To Next Page
Loading...
