108
(3) Make sure only the key fob for registration should be
unlocked. All other key fobs must be locked.
NOTE:
If the other key fobs are not locked during this step, they may
transmit radio waves, which will cause the registration proce-
dure to fail.
(4) Make sure the key fob for registration is placed less than
0.3 m (12 in) from the keyless control unit.
Make sure that the keyless start system is ON and green
LED of the “SELECT” switch of the control panel is ON.
(5) Connect the yellow lead wire and black lead wire located in
the keyless control harness.
Yellow
Black
B
B
Y
B
B
Y
Y: Yellow, B: Black
To Next Page
Loading...
