98
FUNCTION OF COMPONENT PARTS
MAIN KNOB KEY AND EMERGENCY KEY
NOTE:
The main switch panel is shipped from the factory with a regular
key and an emergency key.
The regular key must be in the switch to complete the installa-
tion process.
The emergency key is used to start the engine(s) when the key
FOBs have been lost or misplaced.
Main Knob Key
The main knob key is used for pairing the key-fobs and powering
the system.
Removal: To remove the main knob key, turn the key clockwise
about 15 degrees (between the “Neutral” and ON/
OFF positions), then lift the key out of the cylinder.
Installation: To install the main key knob, insert the key into the
cylinder with light pressure and turn the key about
15 degrees (between the “Neutral” and ON/OFF
positions).
The main key knob is properly installed when it cannot be
removed when lifted in the “Neutral” or ON/OFF positions.
Emergency Key
The emergency key is used to create a pass code and to enter
the pass code to start the engine(s) when all key-fobs have been
lost or misplaced. If the keyless system is installed on a vessel
with multiple engines, the emergency key is used to set the
engine instances.
Removal and installation:
The emergency key must be in the “Neutral” position to be
removed or installed.
Emergency key
“N”
To Next Page
Loading...
