100
INSTANCE SETTING
When the keyless start system is used in multiple motor installa-
tions, the position of each engine, such as PORT, CENTER,
STBD, must be registered in each ECM.
To perform the registration, a laptop computer with the Suzuki
Diagnostic System version 8.20 or later and hardware version 5
or later must be used.
For operation of the Suzuki Diagnostic System Version 8.20,
refer to “Suzuki Diagnostic System Version 8 Operation Man-
ual.”
Necessary tool
The necessary tools are as follows.
NOTE:
“INSTANCE SETTING” must be performed before the initial reg-
istration ID code to the keyless unit and ECM.
NOTE:
The “Instance Setting” is required for the multiple motor installa-
tion only.
It is not necessary to register for the single motor installation.
(1) Connect the diagnostic harness and the USB cable (with a
USB adapter) between the USB port of your PC and the
ECM communication connector (4-pin connector).
Tool name Part number Q’ty
SDS software:
Program Ver. 8.20/
Data base Ver. 8.20
1
Diagnostic harness 1
USB adapter 1
USB cable 1
To Next Page
Loading...
