110
(8) When the ID code registration has been successfully per-
formed:
• The buzzer sounds a short beep to indicate registration
is complete.
Five (5) seconds after the successful registration beep, the
keyless start system buzzer emits a series of beeps to
indicate the number of the key fob just registered to the
system.
– For example, four (4) beeps indicates the key fob just
registered is the fourth key fob registered to the key-
less control unit.
– Remember, a maximum of six (6) key fobs can be reg-
istered on a single keyless control unit.
If the registration is not successful, the red LED on the key-
fob will turn OFF and the system continuously emits short
beeps until the black lead wires are reconnected.
NOTE:
Adding another key fob to the keyless system must be done
within ten (10) seconds of reinstalling the lock plate.
If this is not done, the buzzer continues to sound.
(9) Disconnect the black lead wire from the yellow lead wire
and reconnect the black lead wires on the back of the key-
less start system parts holder.
(10) Make sure the keyless start system can be controlled with
the key fob registered in its ID code.
To Next Page
Loading...
