112
(4) The buzzer starts sounding in the following patterns:
Four (4) long sounds, followed by:
– Two (2) short sounds emitted four (4) times
– Three (3) short sounds emitted four (4) times
– Four (4) short sounds emitted four (4) times
Immediately remove the lock plate from the emergency
stop switch, then reinstall it.
If the unpairing is unsuccessful, the buzzer will continu-
ously emit short beeps until the black lead wires are recon-
nected.
(5) Disconnect the black wire lead from the yellow wire lead,
and then reconnect the two (2) black wire leads.
(6) The buzzer sounds when unpairing is completed success-
fully.
The LED on the “SELECT” switch goes OFF.
(7) Remove the battery cable from the battery.
NOTE:
After unpairing an ECM from the keyless start system, do not
turn the main switch knob to the “ON & OFF” position.
If the switch is turned, the ID code cross-check will be performed
again between the keyless control unit and ECM.
Buzzer sounding pattern
4 times
4 times
4 times
OFF
ON
To Next Page
Loading...
