69
SYSTEM CALIBRATION
Calibrate the system and register information in the BCM.
• SYSTEM FORMATION REGISTRATION
Sets the number of stations and the number of engines and
registers information in the BCM. If two stations are available,
also registers information in both the master BCM and sub
BCM.
• ENGINE LOCATION REGISTRATION
Registers the positions (PORT, CENTER, STBD) of engines
in the BCM.
• LEVER POSITION CALIBRATION
Registers the position (Forward: full opening, full closing, neu-
tral, Reverse: full opening, full closing) of the remote control
lever in the BCM.
NOTE:
To change the system configuration after system calibration, be
sure to initialize the system by using the BCM INITIALIZATION
menu.
• Example: The system is calibrated as a single engine and then
the single engine is changed to the dual engine.
NOTE:
On Quadruple engine:
The electronic calibration for quadruple engine installation is
equal in two times of that for dual engine installation.
• Calibrate the group of port and port center engines first then
the group of starboard and starboard center engines.
• Or calibrate the group of starboard and starboard center
engines first then the group of port and port center engines.
(1) Clicking the “SYSTEM CALIBRATION” button
from the Main Menu dialog box displays the fol-
lowing NOTICE window.
(Keyboard) Select a desired item by using the
“Up” or “Down” arrow key and press the “Enter”
key to have the selected item accepted.
Click the “OK” button and proceed to the next
step.
To Next Page
Loading...
